ftp server web server dns server mail server Streaming server
ftp server
decoration image

 

Running an FTP server behind a router (NAT) had always been hard, almost nobody can success without necessary knowledge and manual configuration on routers and ftp server softwares, you usually need to apply for a dynamic IP domain name, configure your router manually for port mapping setup, configure your ftp server manually because it is behind a NAT so it does not know your real Internet IP-Address for passive connections to use.

Now things had changed , with latest RaidenFTPD v2.4 build 3436+ with UPnP NAT traversal, all the above troubles are all gone, the RaidenFTPD UPnP NAT traversal can do the following things for you automatically

* configure necessary port mapping setup on your router (Internet gateway device) automatically
* detect external IP-Address for PASV mode data connections automatically
* supports dynamic IP changes , detects dynamic IP changes without using a dynamic IP domain name service

UPnP NAT traversal auto setup


required : Windows XP
required : UPnP enabled NAT devices ( Routers )

how to use UPnP NAT traversal (Windows XP only)

1. start raidenftpd.exe
2. if you have an UPnP NAT installed , you should see a Yellow pop window that is asking for permission to alter your port mapping settings


3. click on the check boxes to grant permissions to raidenftpd.exe and click continue
4. when you see the raidenftpd console , you can goto your control pannel -> network connections -> Internet Gateway Devices to browse for mapped ports , if you see port mappings with RaidenFTPD comments then it works


Windows XP ICS/ICF auto setup


required : Windows XP / 2003 platforms
required : Microsoft Internet Connection Sharing installed or Microsoft Internet Firewall installed

1. start raidenftpd.exe
2. if you have ICS/ICF installed , you should see a Yellow pop window that is asking for permission to alter your port mapping settings


3. click on the check boxes to grant permissions to raidenftpd.exe and click continue
4. when you see the raidenftpd console , you can goto your control pannel -> network connections -> Network Interfaces -> Advanced -> Properties to browse for mapped ports , if you see port mappings with RaidenFTPD comments then it works


Hints


Q: How to bring back the yellow popup dialog box if I clicked not to display it again?

A: please delete 2 lines from raidenftpd.ini and restart raidenftpd.exe again

NAT_ICS_AUTO_CONF_WINDOW_CHKSUM=
NAT_ICS_AUTO_CONF_WINDOW=

Q: I bought a new router but the RaidenFTPD gui console displays my old router info?!

A: please delete the router info cache file called ''UPnP_IGD.cache" inside your RaidenFTPD dir.

Q: The yellow popup window appears but I don't see the port mappings on the router

A: Your router may have some problems , try to open a MSN 6.0 messenger and see if a port mapping for MSN is added to your router , if not you can call your router vendor now.

Q: They said my router supports UPnP but I don't see the yellow popup

A: Make sure UPnP is enabled , you need to goto the router's administration program to enable it

Q: I use windows xp and I have an UPnP router but I do not want to use this feature

A: in this case edit raidenftpd.ini NO_UPNP_IGD_SCAN=1 , and restart the program

 

| | | |
decoration image
team johnlong logo decoration image
Copyright © http://www.raidenftpd.com/ 2000- 2024 all rights reserved. The copyrighted works contained in this information service shall not be copied, reproduced, varied, altered, modified, adapted, distributed, performed and displayed in any form without the written permission of the copyright owner. All trademarks belong to their respective owners.
Your WAN IP: 3.149.214.223